Just put spacers on the rear of my car.

[BLUEPSTU]

They are 1 inch spacers. To be honest I wouldn't have minded going with ones a little wider. I like them though.

http://i51.photobucket.com/albums/f380/Iceman1266/th_STA70596.jpg (http://i51.photobucket.com/albums/f380/Iceman1266/STA70596.jpg)
http://i51.photobucket.com/albums/f380/Iceman1266/th_STA70595.jpg (http://i51.photobucket.com/albums/f380/Iceman1266/STA70595.jpg)
http://i51.photobucket.com/albums/f380/Iceman1266/th_STA70594.jpg (http://i51.photobucket.com/albums/f380/Iceman1266/STA70594.jpg)
http://i51.photobucket.com/albums/f380/Iceman1266/th_STA70593.jpg (http://i51.photobucket.com/albums/f380/Iceman1266/STA70593.jpg)

[Rio Red GT]

SWEEEEEEEEEEEEEEEEEEEEET! :thumbsup:

[Ruby SVT]

Cool, when it comes to your car Wide is GOOD.
I have 1" spacers on Ruby and with the 315's its an even sweeter look. I've droped her too, about 1.5",I have not seen any rub what so ever.

[761.2MPH]

Look'N good there Dan! When are the springs going to be here?

[BLUEPSTU]

I know I can't do anything that will lower my car. Because the exhaust of a cobra is so low I prob don't have a centimeter to work with when pulling my car in my drive and that is being very careful when I do that. The GT I had was lowered a good bit but I never had problems but I have scraped close to a dozen times since getting the cobra.

[Rio Red GT]

Invite Glenn over and see if he bottoms out. If he doesn't, get the same springs he has. If he does bottom out.... keep it like it is.

[BLUEPSTU]

I think the exhaust on my year sits lower than his year. I could be wrong but that is what I have been told. I sure would love to be able to lower it though.

[Ruby SVT]

Dan, Is There Anyway You Can Alter Your Drive-way Curb To Smooth Out Or Fill In The Rise Between Your Street And Drive Way?
I've Seen Some Guys Make Wooden Fillers.

[BLUEPSTU]

I don't know. If I could even build 2 simple little wood ramps to pull out of the back of my truck when I pull the car in or out would be great. Of coourse going anywhere that had speed bumps would be murder. I have to go over every speed bump at a huge angle now. I have to let the passenger wheel go over way before the driver side then turn it hard to the right afterwards. All of this while driving very slow. Remind me to let you look at it next time we are around. I don't know why it is like this.

[chromebullitts]

Dan the car looks great and even better with the spacers. IMO the 1" brought the tire out just right - nice job.

[BLUEPSTU]

Thanks Joel. I'm liking it more and more.

[jnatale3]

Looks good Dan, read my PM about the alignment.

[xxthepharaohxx]

The Pony looks great! :thumbsup: